Configure ARP ACEs

Use ACE Address Resolution Protocol (ARP) entries to ensure the filter looks for ARP requests or responses.

You cannot configure ARP attributes for IPv6 filters.

Before you begin

Enter Global Configuration mode:

enable

configure terminal
Configure an ACE for ARP packets:

filter acl ace arp <1-2048> <1-2000> operation eq <arprequest|arpresponse>
Ensure the configuration is correct:

show filter acl arp <1-2048> <1-2000>
Optionally, delete the individual attributes from the ARP portion of the ACE:

no filter acl ace arp <1-2048> <1-2000> [operation]
Optionally, delete all the attributes from the ARP portion of the ACE:

default filter acl ace arp <1-2048> <1-2000>

Use the data in the following table to use the filter acl ace arp command.


Variable	Value
`<1-2048>`	Specifies the ACL ID.
`<1-2000>`	Specifies the ACE ID.
operation eq <arprequest\|arpresponse>	Specifies the type of ARP operation to filter: arpRequest or arpResponse.